Copyright © 2021 Minghui Technology Co., Ltd. All rights reserved Site MapDesigned by
For clay desiccants, it will be overpowered by the condition, as this condition will be too extreme for it. So, it won't be able to remove enough moisture because it's not capable. Therefore, calcium chloride are ideal desiccant for containers.
In extreme cases, it may experience temperatures as high as 70-80°C and as low as -10 to -20°C during the shipping process. It is required that the container desiccant can maintain the moisture absorption capacity at these temperatures, and has the effect of reducing the air humidity in the container.
The insulating glass desiccant is mainly suitable for the adsorption of moisture in the insulating glass interlayer gas, and continuously absorbs the moisture entering the spacer layer during the life of the insulating glass; avoids glass fogging, and keeps the insulating glass clean and transparent even at very low temperatures. , Improve the thermal insulation, sound insulation and heat insulation performance of insulating glass, thereby reducing energy consumption and fully extending the service life of insulating glass. 3A molecular sieve has strong hygroscopic ability and is used for gas purification. Avoid direct exposure to the air during storage. 3A molecular sieves that have been stored for a long time and have absorbed moisture should be regenerated before use. Molecular sieves avoid oil and liquid water. When using, try to avoid contact with oil and liquid water.
Nowadays, electronic components are developing towards miniaturization, and packaging is also gradually developing towards cheapening. General electronic components are plastic package. However, the disadvantage of plastic packaging is that the moist gas will enter the interior of the device through the packaging material and the joint surface of the components, which will cause the internal circuit to oxidize, corrode, and short-circuit on the one hand.
In this present time where the environment leaders are putting pressure on RECYCLING & REUSING, reuse of Silica Gel packets might be a perfect example to set this ideology. These pouches are ideal for reusing at home, at offices and other places to keep an area moisture-free.
Ensure that the oxygen absorber is well sealed before you place it inside in the food packed and also ensure you seal the food pack or products immediately the container is filled because if the amount of oxygen content is much and the iron powder will be supersaturated causing food spoilage within short period of time.